Hi, I would like to add a shoulder dart to my pattern by adding some length to the center back as in the picture below. I tried to cut my pattern open and move the upper piece up 0,5 cm and then putting the dart in with dart with fullness. But in this film (<a target="_blank" rel="noopener noreferrer nofollow" href="https://www.youtube.com/watch?v=WWwjav-SvdA&amp;t=2s">https://www.youtube.com/watch?v=WWwjav-SvdA&amp;t=2s</a>) while opening up the dart, you see the moving pattern piece, I only see the dart opening up which makes it hard to match up the 2 points at the armhole. Is there a way to see the moving pattern pieces or is there a better way all together to do this? Thanks for the help!<img src="https://storagefiles.clo-set.com/public/community/202503/ffa4c2bb001247578744a870b0d84ce3/images/1f3f08e9afc64cb2bf493c3584b737a0Scherm%C2%ADafbeelding%202025-03-28%20om%2014.19.18.png" alt="1f3f08e9afc64cb2bf493c3584b737a0" class="custom-image original-size" data-id="1f3f08e9afc64cb2bf493c3584b737a0" data-width="1052" data-height="510"><img src="https://storagefiles.clo-set.com/public/community/202503/ffa4c2bb001247578744a870b0d84ce3/images/da791751219a45a5bbc1bf0688a866eeScherm%C2%ADafbeelding%202025-03-28%20om%2014.19.18.png" class="custom-image hidden-thumbnail" data-id="da791751219a45a5bbc1bf0688a866ee" data-width="1052" data-height="510"><img src="https://storagefiles.clo-set.com/public/community/202503/ffa4c2bb001247578744a870b0d84ce3/images/2ad7ba5ac1974ecc9589fa0c95cdb37aScherm%C2%ADafbeelding%202025-03-28%20om%2014.19.18.2.png" class="custom-image hidden-thumbnail" data-id="2ad7ba5ac1974ecc9589fa0c95cdb37a" data-width="444" data-height="443">